Power Transformer MCQs Part 07

61. A transformer can have zero voltage regulation at
a. zero power factor
b. lagging power factor
c. leading power factor
d. unity power factor

62. The leakage impedance of primary and secondary of a transformer are ( 3 + j4 ) ohms and ( 1 + j4 ) ohms respectively . it can be concluded that the transformer has
a. low voltage primary
b. low voltage secondary
c. high voltage secondary
d. no conclusion can be drawn on the basis of the information given

63. The colour of dry silica gel is
a. pale yellow
b. pale pink
c. pale green
d. blue

64. The colour of most silica gel is
a. red
b. brown
c. blue
d. yellow

65. A transformer has a copper loss of 1.5% and reactance 3.5% when tested on load . it will have better regulation at
a. Unity power factor
b. 0.8 lagging p.f
c. 0.8 leading p.f
d. none of the above

66. In a 50 Kva transformer the number of turns in the primary and secondary winding are 834 and 58 respectively. If the primary is connected to 3300v. Supply the secondary current will be:
a. 15A
b. 30A
c. 218A
d. 438

67. In full load copper loss of transformer is 800w. its copper loss at 75% load will be:
a. 800w
b. 450
c. 400
d. 200

68. The essential condition for parallel operating of two single phase transformer is that they should have same
a. efficiency
b. capacity
c. voltage ratio
d. polarity

69. In a transformer the resistance between the primary and secondary must be
a. Zero
b. 1 K resistance
c. 100 K resistance
d Infinite

70. The secondary of a current transformer is always short circulated under operating conditions because
a. It avoid core saturation and high voltage induction
b. it avoid high voltage surges
c. it protects the primary cell
d. it is same for operation

Previous

Next